Can not register at end of installing
Step1: Reboot computer, then check service status
$ sudo reboot
$ sudo service eveusb status
If status show "eveusbd is running", go to Step2.
Not running, go to Step 3.
Step2: Execute /opt/Eltima/eveusb/bin/reg.sh to register service.
$ /opt/Eltima/eveusb/bin/reg.sh
Step3: Check SELinux status.
$ getenforce
If get status "Enforcing", Disabling SELinux.
Configure SELINUX=disabled in the /etc/selinux/config file:
# This file controls the state of SELinux on the system.
# SELINUX= can take one of these three values:
# enforcing - SELinux security policy is enforced.
# permissive - SELinux prints warnings instead of enforcing.
# disabled - No SELinux policy is loaded.
SELINUX=disabled
# SELINUXTYPE= can take one of these two values:
# targeted - Targeted processes are protected,
# mls - Multi Level Security protection.
SELINUXTYPE=targeted
Reboot your system. After reboot, confirm that the getenforce command returns Disabled:
$ getenforce
Disabled
Then execute Step2.